Installation of Flotation Machine

27adfb3129612d531188ef5a62c91170 副本

Installation of Flotation Machine

Installation of Flotation Machine

The installation requirements for the flotation machine are as follows:

(1) The installation of the flotation machine and the assembly of the tanks must meet the process configuration requirements of the mineral processing plant.

(2) The clearance between the rotor and stator of the flotation machine’s agitation mechanism shall comply with the provisions of the design documents.

(3) The permissible deviations and inspection methods for the installation of the flotation machine shall comply with the provisions of Table 12-20.

Table 12-20 Permissible deviations for installation of 浮選機

Item No.品目Permissible deviation単位Inspection method
1Longitudinal and transverse centerline3.0うーんPull line and measure with ruler
2Elevation±5.0うーんSteel ruler or level gauge
3Longitudinal and transverse levelness0.3/1000—Level gauge measured on the vertical shaft pulley
4Height difference of overflow weir5以下うーんLevel gauge measurement
5Relative position difference after connecting all tanks±5.0うーんRuler measurement
6Parallelism between scraper shaft and overflow weir3.0うーんRuler measurement
7Coaxiality of bearings on scraper shaft2.0うーんPull line and measure with ruler

12.7.2 Trial operation of flotation machine

The trial operation of the flotation machine shall comply with the following provisions:

(1) Fill the tank with clean water and run continuously for not less than 2 hours. The rotation shall be flexible without jamming or interference.

(2) The temperature of rolling bearings shall not exceed 80 °C.

(3) The belt drive shall not exhibit edge wear or slipping.

(4) The chain drive shall not exhibit jamming or abnormal noise.

(5) The gear drive shall not exhibit abnormal noise or vibration.

(6) No fasteners or connecting parts shall become loose.

Only after the above trial operation provisions are met without any problems may the slurry be fed for load trial operation.

こちらの商品もおすすめです

振動台

振動台

振動台 – 高精度重力濃縮機 製品概要 振動台(別名…
SAM 機械式破砕機

SAM 機械式破砕機

SAM 機械式破砕機 SAM 機械式破砕機は、日本とドイツの技術を融合させ、…
ロッド・ミル

ロッド・ミル

ロッドミルの構造 湿式ロッドミルは、次のように分類される…
Copyright © 2026 Oreprocessings. All Rights Reserved.